Orginally posted on FineHomeBuilding.comby Jamie Goldberg
The house I grew up in had only one full bathroom, which my parents, sister, brother, and I shared. Somehow, we made it work, as do millions of families today. But almost any bathroom will work better if a little more storage is added to the mix. The best time to maximize a bathroom’s storage capacity is, of course, at the design stage, but you can explore plenty of storage-boosting options while remodeling or simply when updating fixtures and cabinetry.
Whether incorporated into the original design or added after the fact, bathroom-storage expansion its into three categories: (1) increasing the capacity of traditional storage areas like vanity cabinets; (2) maximizing existing floor and wall space with new storage options; and (3) identifying storage possibilities in spaces that are not traditionally used for storage. These approaches are outlined on the next page, and strategies from all three are used in the illustrated examples.
False panels in the sink bases have been converted to tilt-out trays for toothpaste and dental-floss storage. Doors are equipped with storage racks, including one for hair dryers. If extra storage is needed, U-shaped shelves can double the capacity of the sink cabinets. The center drawer’s functionality is increased with a tiered divider, while the basic linen tower has been made more useful with a quartet of roll-out trays in the lower section.
1. Increase the capacityof traditional areas • Add two-tiered organizers to any 4-in. or taller vanity drawer boxes, thus creating extra half-drawers without altering the existing cabinet. • Install a storage rack on the back of every vanity base-cabinet door. Special racks are available for space-hogging hair dryers. • Add roll-out trays to the bottom of base cabinets, and use them in place of shelves in linen towers, making what’s stored in the back more visible and accessible. • Wrap a U-shaped shelf around undersink plumbing to add an extra level of storage. • Convert the false panel below a vanity countertop to a tilt-out tray.
2. Maximize existing floor, surface, and wall space • Maximize point-of-use vanity storage with countertop cabinetry. Use 12-in.-deep cabinets, keeping them at least 3 in. from the sink edge to prevent water damage. The cabinets can extend to the ceiling with a decorative crown molding, or stop a foot lower if there’s a vent or light above. Regardless of height, they should be finished with a topcoat that protects against moisture, and be kept as dry as possible to prevent moisture damage at the point of contact with the vanity top. • Increase point-of-use commode storage. If it is not situated under a window, install a single or stacked cabinet to the ceiling above the toilet. It should be low enough for a seated user to reach inside and extend no farther out than the toilet tank to avoid causing injury. • If there is a window directly above the toilet, space might still exist for a shorter cabinet or shelf to be installed between the window and the ceiling for backup supplies. Ensure that the bottom is finished because it will be highly visible. • Take advantage of unused floor space to create a built-in furniture armoire, floor cabinet, or storage bench for backup and occasional-use items. Remember to allow for clearances when adding storage of this type. National Kitchen & Bath Association design guidelines recommend 30 in. in front of a vanity, commode, or shower. NKBA guidelines are often more stringent than building codes, but be sure to check local requirements to ensure that you’re in compliance whenever undertaking a bathroom project.
3. Identify storage possibilities in nontraditional spaces • Add a finished shelf above the bathroom entry door to take advantage of otherwise unused space for occasional-use items. Whenever possible, run it wall to wall. • Take advantage of the forgotten space behind an in-swing door by building a tall, shallow cabinet into the wall between studs. • Create a shower-wall niche for each bathroom occupant to accommodate daily point-of-use bathing items. At least one should be built within 15 in. of the shower bench for seated access. • Plan open-storage cubbies for towels or bath supplies on the front end or exposed side of a new tub deck. • Plan built-in, open wall-shelving units at one or both ends of a tub-only enclosure for daily point-of-use bathing items in storage baskets.
Drawings: Martha Garstang Hill
From Fine Homebuilding217 , pp. 88-92 January 20, 2011 © 2012 The Taunton Press, Inc. More good stuff from Fine Homebuilding here.